The XXXII Symposium on Mathematical Physics
June 6-10, 2000, Torun, Poland
Guidelines for the preparation of
materials
for the symposium proceedings
General information
-
Symposium proceedings will be published as a special issue
of the Reports
on Mathematical Physics
-
Contributed papers should not be published or submitted for
publication elsewhere.
-
Page limit is 12 pages for invited talks and 8 pages for
other presentations.
-
Papers should preferably be prepared in TeX or LaTeX using
romp32.sty
style file (cf. below).
-
Two hard copies of each contribution should be submitted
to the address
R. Mrugala
Managing Editor, ROMP
Institute of Physics, N. Copernicus University
Grudziadzka 5
87-100 Torun, Poland
e-mail: romp@phys.uni.torun.pl
-
The TeX source file should be e-mailed to the address
romp@phys.uni.torun.pl
only after the paper has been accepted for publication.
-
Figures should be prepared on separate sheets of good quality,
white A4 paper. PostScript (PS
or EPS) is the preferred
format for graphic files.
-
Bibliography should conform with the ROMP standards (cf.
the file example.tex linked
below).
-
Papers will be refereed.
-
The deadline for submission of materials is August 30, 2000.
LaTeX style file
romp32.sty
Using romp32.sty
style file will make your LaTeX output look like a paper in ROMP, hence
it will help you keep within the page limits, preview line breaks, etc.
Here are some more detailed instructions.
-
Download the style file romp32.sty
by clicking here: romp32.sty
.
-
Save it (named
romp32.sty
)
in the same directory where your paper LaTeX source file(s) is kept and
processed.
-
Your paper should be prepared in the standard LaTeX
"article" or
"report" style syntax.
romp32.sty
just alters the meaning of typical commands, like \maketitle,
\section,
etc., so there are no new things to learn. Please, study the short exemplary
file
example.tex
.
-
romp32.sty
works fine with both LaTeX 2.09 and LaTeX2E. With LaTeX 2.09 you simply
begin your source file with
\documentstyle[romp32]{article}
...
while with LaTeX2E it should be
\documentclass{article}
\usepackage{romp32}
...
-
Do not change any formatting (lengths), numbering or referencing
definitions in the romp32
style. The papers are eventually processed as a single LaTeX job and similar
macro names appearing in different papers cause problems which are often
hard to detect. Therefore, the use of private macros should be reduced
to a necessary minimum; if you use any, please do not forget to include
them in the source of your paper, avoiding short names likely to be repeated,
e.g. "\be" for "\begin{equation}"
or for "\beta". Do not use
local macro packages which are not standard, in particular do not
use
Scientific Word. Discard from your source file any macros not used in this
file.
-
The source file should not contain lines longer than 80 characters.
Also discard from your file any lines commented out by "%". The
file will be reformated by us, and short lines make our work easier.
-
In case of any problems or questions do not hesitate to contact
us at romp@phys.uni.torun.pl
-
You may also visit the ROMP www site at http://www.phys.uni.torun.pl/zfmis/romp/
for related information.
Back
to XXXII SMP page